Meter base hookup

meter base hookup

How do I wire a meter base?

All mounting for the base should be in place before wiring. There are two kinds of wires that may be used by the utility company: aluminum wires or copper wires. If aluminum wires are used, an anti-corrosion compound must be used to protect the wires from corrosion. Identify the line side and the load side of the meter base.

How do you identify a meter base?

Identify the line side and the load side of the meter base. The line side is where the service drop from the utility company is attached. There should be three wires: two hot wires and one neutral wire.

How do I install the service panel on the meter base?

Insert the wire into the appropriate socket, then tighten the screw with the Allen key provided. Identify the load side on the meter base. This is where the wires going to the service panel are installed. There are three sockets.

How do you hook up a meter to a new socket?

The line side wires should connect to the upper terminals on the new meter, while the bottom terminals are for the load side wires. Place the new meter into the socket and reconnect the high-voltage feed and ground wire.

How do you identify a meter base?

Identify the line side and the load side of the meter base. The line side is where the service drop from the utility company is attached. There should be three wires: two hot wires and one neutral wire.

How do you install a meter base on the ground?

Place one end of the No. 6 wire through the proper hole in the bottom of the meter base. Leave enough slack to connect it to the small ground lug. Strip a half inch of insulation off the No. 6 wire. Place the No. 6 wire under the ground lug, and tighten it securely. Scoop out about three inches of dirt under the meter base to make a shallow hole.

How do you wire a meter base to a neutral wire?

The hot wires are installed on both sides of the meter base, not in the middle. Repeat the steps with the second hot wire. Install the neutral wire in the middle of the socket or to the neutral bar marked on the meter base. The neutral bar is identified by a white marking or white electrical tape on the outer sheath.

How do I choose the right wire for my electric meter?

If aluminum wires are used, an anti-corrosion compound must be used to protect the wires from corrosion. Identify the line side and the load side of the meter base. The line side is where the service drop from the utility company is attached. There should be three wires: two hot wires and one neutral wire.

How do you hook up an electric meter to a panel?

The load side of the electric meter, which carries power to the main service panel, can be wired either directly to the panel or to an interim disconnect. To do this, the ends of the two hot load wires are stripped and connected to the bottom two load terminals on the meters hot bus bars.

How do you connect a ground wire to a meter socket?

Connect the assembly to the ground rod that should previously have been installed in the earth. The bare copper ground wire should be connected to the “ground” terminal in the meter socket.

How are the wires in a meter box connected?

The actual wire connections are quite easy to understand. Three large-gauge stranded wires (two hot wires and one neutral) enter the meter box from a weather head on a metal mast (or from underground service) and are attached to the corresponding line terminals on the hot and neutral bus bars in the meter box.

How do you connect a neutral wire to an electric meter?

Before you can connect the electric meter neutral wire, you must first know how the wire is marked and why. The wire marked with the white tape is the neutral wire and it is attached to the neutral lug terminal. The terminal is located directly in the center of the meter between the two hot wires.

Related posts: