How do you hook up a propane pool heater

how do you hook up a propane pool heater

How does a propane pool heater work?

The pump forces water from the intake into the unit where the propane gas heats up the water. Warm water will now exit through the pool jets. The heater starts up each time the temperature goes below the desired setting. The heater will only turn on when the temperature is below its designated level.

How do I install a propane pool heater?

The heater will normally need to be located close to the propane tank. Take the heater out of the box and position it on the cement slab. Few heaters will be bolted to the ground and will simply connect to your pools plumbing lines and propane tank. The heaters are quite heavy and this is what will keep the heater in the right position.

Can you put a propane pool heater on a concrete slab?

The propane pool heater should be placed on a level concrete slab so that the heater is stable. If you have gas available then you might consider using a gas heating system rather than propane as it will be cheaper. The heater will normally need to be located close to the propane tank.

What happens if you hook up a pool heater wrong?

An improper hookup could potentially be very dangerous. Turn the pump on to test the heater. The pump will force water from the pools intakes into the heater, where gas will be burned to heat up the water. The now warm water exits the heater to feed the jets on the side of the pool.

How does a gas pool heater work?

A typical gas-powered pool heater has a combustion chamber that burns either natural gas or propane. These pool heaters usually have copper coils where the pool water passes through and gets heated. The heated pool water is then pumped back to the swimming pool.

Can You Heat a pool with a propane pool heater?

Using a propane pool heater is one of the most effective ways to heat your pool water, and it’s highly capable of heating a pool in cold weather temperatures below 55°F. Propane heaters have various heat output, in BTU’s, and most manufacturers offer models with 100,000 BTU up to 400,000 BTU, with many sizes in between.

How much heat does a pool heater produce?

Pool heaters can be anywhere from 80% to 95% efficient. If we use 80% efficient pool heater as the average, your 400,000 btu heater will actually output 320,000 BTU’s per hour. Enough math, what’s the simple answer already. If you run your 400,000 BTU heater for one hour you will raise the temperature approx 1.828 degrees.

How do you hook up a pool heater?

Few heaters will be bolted to the ground and will simply connect to your pools plumbing lines and propane tank. The heaters are quite heavy and this is what will keep the heater in the right position.

Why is the water in my Pool not heating up?

Ensure that the pool heater’s thermostat has a higher temperature setting than the current water temperature of your pool. This way, the water being pumped in is actually warmer. With some pool heat pumps, if it is not warm enough, the heater will not run and keep up the water.

What are the most common problems with pool heaters?

One of the most common problems with pool heaters is it failing to ignite. Is your heater turned ON and the temperature set correctly? Ensure that the thermostat is set to a higher temperature than the current water temperature. Is your pump running with a clean filter and basket?

What should I do if my pool heater is not working?

Inspect your heat exchanger for chemical or sanitizer damage. Sometimes, your pool heater ignites but doesn’t reach the desired temperature. Or, maybe your heater isn’t generating heat at all. Both situations are very common. Inspect your temperature sensor.

How do I know if my pool heater is getting enough water?

Pool heaters rely on a steady stream of water in order to operate properly, and when this is interrupted, you will start to run into issues. To make sure that your pool heater is getting enough water, you need to check your filter.

Related posts: