Dating antique drawer pulls

dating antique drawer pulls

How were the drawer pulls attached to the drawer?

The handle on these pulls was linked to a double strip of brass or iron which passes through the drawer front and was then parted and turned over so that each end was pinned to the drawer back. From about 1690 the brass loop handle with solid back plate appeared.

What does the dovetail joint reveal about the age of furniture?

As the dovetail joint evolved through the last one hundred thirty years, it becomes a clue for the age and authenticity of antique furniture. The type of dovetailed joint, especially in drawers, reveals much about furniture construction and dating.

When did they start using dovetails in drawers?

Other drawer joints include sliding keyhole or French dovetails that were have been used since the 1890’s. Here is an oak cylinder roll desk from about 1895 with keyhole dovetailed drawers. European cabinetmakers continued to produce hand-cut dovetails through the 1930’s.

Why do old drawers have so many different types of wood?

Old original drawers were normally built with a minimum of two woods and can be found with as many as three to four. Thats because different woods were used for different purposes. The main wood or primary wood was used for the most important exposed surfaces. Woods which were exposed but in less noticeable areas are called secondary woods.

What is a drawer pull called?

A drawer pull ( wire pull or simply pull) is a handle to pull a drawer out of a chest of drawers, cabinet or other furniture piece. A drawer pull often includes a plate to which the handle is fastened. The handle may swing from one or two mounts (drop handle or swing handle), making a drop drawer pull.

How do you attach a drawer pull to a drawer?

Hold the drawer pull on the front of the hole and drive a screw through the back side and into the drawer pull. Place a compass on the drawer front to determine where to drill holes for a handle-style drawer pull. Adjust a compass to match the distance between the centers of the handles attachment holes.

What is the difference between a drawer pull and bail handle?

A drawer pull often includes a plate to which the handle is fastened. The handle may swing from one or two mounts (drop handle or swing handle), making a drop drawer pull. A bail handle is a kind of swing handle consisting of an open loop attached to two mounts.

Do drawer pulls and knobs come with predrilled holes?

Cabinets sometimes come with predrilled pull or handle holes, but often manufacturers leave the hole drilling up to you for a greater hardware selection as the mounting holes in two-holed handles aren’t always a standard distance apart. If youve made cabinets, determining where and how to install drawer pulls and knobs allows you to finish them.

How many wood types of drawers are in an old drawer?

Old original drawers were normally built with a minimum of two woods and can be found with as many as three to four. Thats because different woods were used for different purposes.

Why is plywood used to make drawers?

This is because plywood is flat, strong, and dimensionally stable (it expands and contracts much less than solid wood). Its also much easier to cut a single piece of plywood to fit a drawer box than to glue up a bunch of hardwood planks.

What kind of wood is used for drawer bottoms?

Wood for Drawer Box Bottoms. Assuming youre going with plywood for the drawer bottoms, youll get the best results with real hardwood plywood, which is made entirely with thin plies of real hardwood.

Why do drawers have to be below the table?

Over many years the dirt, dust, grease and smoke circulating in room air is absorbed by the exposed bottom of the lowest drawer (Fig. 1). Less air reaches upper drawers because they are protected by the drawer (s) below.

Related posts: