3-way switch hookup

3-way switch hookup

How do you hook up a 3 way switch?

Hook the curled end of the wire under the screw, then tighten down the screw to hold the wire firmly in place. This screw is usually in the upper left side of the switch and is painted black, but check the guide that comes with your switch if youre unsure. Not all switches are made for three-way wiring.

Where does the Red Wire go on a 3 way switch?

The 3 wire cable enters through the top of the first switch box. The red insulated wire connects to either one of the 2 unused terminal screws (shown in the image above to be on the top left and right sides of both 3-way switches). It does not matter to which terminal screw this wire is connected.

Where does the hot wire go in a 3 way circuit?

The hot wire from light always goes to the common terminal of the second switch. The traveler wires go from switch to switch connected to the traveler terminals, it doesnt matter which. As long as you keep this in mind, a 3-way circuit becomes really simplified.

How do you turn a single pole switch into a 3-way?

Converting a Single-Pole Switch to a 3-Way Run a black wire from the new switch to the power source. Connect another black wire from the light to the original switch location. Cap the white neutral wires to each switch box. Connect the traveler wires using the bottom conductor.

How do you wire a 3 way switch?

You have two options for wiring a 3 way switch: running the power through the switches to the light or from the light to the switches. In both options, we’ll have four colors of wire, and you need to understand their different uses before we move on. Black - This is a HOT wire, meaning that power is running through this wire.

How do you hook up a light switch?

Run a black wire from the new switch to the power source. Use the black wire in the top 2-wire conductor to attach the switch to the source. Make a J-hook in the wire with a pair of pliers and wrap it around the black common screw on the light switch. Tighten the screw to secure it in place. Cap the wires connecting the source and the switch.

Where does the hot wire go in a 3 way circuit?

The hot wire from light always goes to the common terminal of the second switch. The traveler wires go from switch to switch connected to the traveler terminals, it doesnt matter which. As long as you keep this in mind, a 3-way circuit becomes really simplified.

What should I look for when buying a 3-way switch?

Before you start installing, take a look at your new 3-way switch to identify all of the terminals that you will be connecting wires to. Traveler wire terminals - These are located on each side of the switch towards the top of the switch. Ground wire terminal - Older switches may not have this, but all new switches must.

How do you hook up a single pole 3 way switch?

Single Pole Switch on Load Side In the line side box, remove the 3-way switch. Using a wire connector, connect the line wire to one of the traveler wires to supply line voltage to the 3-way switch in the load side box. Install a wire connector on it the other traveler to make it a spare.

How do you hook up a 3 way switch to a light?

Attach a wire connector to cap off the other end of the spare traveler wire. Connect the 3-way switch common wire to the other traveler wire to supply switched line voltage to the light.

Which wire is the power wire on a 3 way switch?

Remember that the wire that has a black, white and ground is the power wire. The wire that has the black, red, white and ground, connects to the two screws on the two screw end of the 3 way switch.

How does a single pole light switch work?

A single pole switch is easy to understand. It has two brass terminals, one for the hot wire from the power source and one for the hot wire to the fixture. When the switch is off, the connection between these two wires is broken, and the fixture gets no electricity. Flip the switch on and electricity flows.

Related posts: